Amx Mio Modero Device Family User Manual download pdf (Page 10)

Installation

Mio Modero Device Family

Changing Buttons

The Mio Modero Classic and Elite are shipped with "installation" buttons; they are intended to be place

holders until your engraved buttons, designed with KeypadBuilder, arrive.

Switching Out "Installation" Buttons

Pry the button using the slot on the front of the "installation" buttons to remove them from the Mio

Modero.

2. Select the location of the custom buttons and snap them into place.

Be sure to note the orientation of the white insert on the back of the button, the notch must be down.

Insert the bottom of the button first and then push the top into place.

3. Snap the faceplate on the mounting frame.

Changing Custom Buttons

If connected, disconnect the power supply.

2. If connected to mounting frame, place a flathead screwdriver in the notch at the bottom right of the Mio

Modero, and pry the faceplate from the mounting frame.

3. On the back of the faceplate locate the button access points, outlined with white circles. Using a

straightened paperclip, poke through the button access points until the buttons pop free.

4. Snap the desired custom buttons into place.

Be sure to note the orientation of the white insert on the back of the button, the notch must be down.

Insert the bottom of the button first and then push the top into place.

5. If the power supply was disconnected in Step 1, reconnect and return power to the device.

6. Snap the faceplate on the mounting frame.

Be certain to reprogram the Mio Modero to match the new button arrangement; use KeypadBuilder to assign

the locations. See the KeypadBuilder Instruction Manual available at www.amx.com.

FIG. 3 Sections of The Mio Modero

LCD

Mounting

Faceplate

Installation Buttons

Frame

1 ... 9 10 11 ... 28

No comments

Amx Mio Modero Device Family User Manual Page 10