AMX AXP-AI8 ANALOG 8-INPUT BOARD Instruction Manual download pdf (Page 65)

Appendix A - Telnet (Terminal) Commands

Instruction Manual - Solecis Digital Switchers

Notes on Specific Telnet Clients

Telnet and terminal clients exhibit different behaviors in some situations. This section states some of the known

anomalies.

Windows Client Programs

Anomalies occur when using a Windows® client if you are not typing standard ASCII characters (i.e., using the keypad

and the Alt key to enter decimal codes). Most programs will allow you to enter specific decimal codes by holding Alt

and using keypad numbers.

For example, hold Alt, hit the keypad 1, then hit keypad 0, then release Alt. The standard line feed code is entered

(decimal 10). Windows will perform an ANSI to OEM conversion on some codes entered this way because of the way

Windows handles languages and code pages.

The following codes are known to be altered, but others may be affected depending on the computer’s setup.

Characters 15, 21, 22, and any characters above 127.

This affects both Windows Telnet and Terminal programs.

Linux Telnet Client

The Linux Telnet client has three anomalies that are known at this time:

A null (\00) character is sent after a carriage return.

If an “Alt 255” is entered, two of the “255” characters are sent (per the Telnet RAFT).

If the code to return to Command mode is entered (Alt 29 which is ^]), the character is not sent, but the Telnet

Command Mode is entered.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70

No comments

AMX AXP-AI8 ANALOG 8-INPUT BOARD Instruction Manual Page 65