AMX AXP-AI8 ANALOG 8-INPUT BOARD Instruction Manual download pdf (Page 25)

Device Connectors

Instruction Manual - Solecis Digital Switchers

Inputs and Outputs

The following sub-sections describe each component on the rear panel of the switchers. Refer to FIG. 3 on page 13 for

the complete layout of the rear panel.

HDMI INPUTS

The HDMI INPUT connectors on the rear panel route digital video (and audio) from connected source input devices to

the connected output devices. The SDX-410-DX features four connectors, while the SDX-810-DX features eight and the

SDX-510M-DX features three.These inputs support the following audio formats:

Dolby TrueHD

Dolby Digital

DTS-HD Master Audio™

DTS

Note: 2 CH through 8 CH L-PCM Dolby Digital and DTS support up to 48kHz, 5.1 channels.

FIG. 10 displays the HDMI INPUTS for the SDX-410-DX.

FIG. 10 HDMI INPUTS

For more information about these connectors, including wiring, see the HDMI INPUTS section on page 21.

GROUP INPUTS (SDX-510M-DX only)

The two GROUP INPUTS areas on the rear panel each feature an HDMI port, a 15-pin VGA port, a 1/8" mini-Stereo

jack, and a 5-pin 3.5mm Dual External Button/LED Control connector.

The HDMI input supports a digital audio/video source. The VGA input port supports analog video. Use the 1/8"

mini-Stereo jack for analog audio. Though these two sets of input ports support separate digital and analog video

sources, you can only select one input at a time to be sourced to the output ports.

The SDX-510M-DX has two sets of groups in which the first external button LED control connector is used to cycle

through the inputs within a particular group. On the SDX-510M-DX, HDMI INPUT 1 is always the first input on both

groups. Group 1 contains inputs 1, 2, and 3. Group 2 contains inputs 1, 4, and 5. You can route the audio/video from one

input within a group at a time.

You can cycle through the inputs in each group by clicking a single button module connected to the Dual External

button/LED Control connector for each group (see FIG. 11). For group 1, connect the single button module to contact

closure 2. For group 2, connect the single button module to contact closure 4. Connecting button modules to contact

closures 3 or 5 will not have any effect on switching within either group. Contact closures 3 and 5 are not tied to specific

inputs, but you can use them for an auxiliary button press trigger event notification which can be recognized by a

NetLinx Master for programming purposes.

Note: If there is no signal available on both the HDMI and VGA inputs in a single group, a remote button press toggles

to input 1 and the switcher displays black video with analog audio from the group.

Note: With Group Input button switching, connection to a Master is not needed. The button press results in the switcher

directly cycling through the inputs in the group.

FIG. 11 displays the GROUP INPUTS area.

FIG. 11 GROUP INPUTS area

mini-Stereo jack

VGA portHDMI port

Dual External button/

LED Control connector

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 69 70

Comments to this Manuals

No comments

AMX AXP-AI8 ANALOG 8-INPUT BOARD Instruction Manual Page 25

Comments to this Manuals

Related products and manuals for Networking AMX AXP-AI8 ANALOG 8-INPUT BOARD