AMX AXP-AI8 ANALOG 8-INPUT BOARD Instruction Manual download pdf (Page 26)

Device Connectors

Instruction Manual - Solecis Digital Switchers

OUTPUTS

One HDMI connector and one DXLink (RJ-45) port transport digital video, embedded audio, Ethernet, and

bi-directional control over twisted pair cable to DXLink devices or boards, including digitally transcoded analog video

signals. Both inputs support HDCP.

FIG. 12 displays the HDMI and DXLink output ports.

FIG. 12 Output ports

See the Important Twisted Pair Cabling Requirements and Recommendations section on page 25 for information about

cable requirements for the DXLink port.

LAN 10/100

The LAN 10/100 RJ-45 ports provide 10/100 Mbps TCP/IP communication. These are Auto MDI/MDI-X enabled ports,

which allow you to use either straight-through or crossover Ethernet cables. The port LEDs show communication

activity, connection status, speeds, and mode information. The SDX-410-DX and SDX-810-DX each feature two LAN

OUT ports located on the back panel of the units. The SDX-510M-DX features three LAN OUT ports located on its front

panel.

FIG. 13 displays the LAN 10/100 ports.

FIG. 13 LAN 10/100 ports

FIG. 14 describes the blink activity for the LAN OUT port and cable.

FIG. 14 LAN connector / LEDs

PROGRAM Port

The PROGRAM port is a USB mini-B connector that connects the switcher to a communication port on a PC, and

supports the DGX Configuration Software for programming a custom VGA EDID.

FIG. 15 displays the PROGRAM port.

FIG. 15 PROGRAM port

A L

L/A - Activity LED (green)

lights when receiving or

transmitting LAN

data packets

SPD - Link LED (amber) lights when

the connection speed is 100 Mbps

and turns off when the speed in 10 Mbps.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 69 70

No comments

AMX AXP-AI8 ANALOG 8-INPUT BOARD Instruction Manual Page 26