AMX AVB-WP-TX-MULTI-DXLINK Instruction Manual download pdf (Page 147)

Appendix G - Ground Wire Attachment

141

Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver

Appendix G – Ground Wire Attachment

Applicability

This appendix covers attaching a ground wire to a DXLink Module without a designated ground

location. If the module has a designated ground screw, see page 45.

If the system is experiencing problems with delivery of DXLink signals to/from an Enova DGX Digital

Media Switcher or Enova DVX Solution, adding a ground wire from the TX/RX to the switcher may

improve performance. The problem is likely caused by the use of a single phase powered system that

does not provide an earth ground for a source or destination's chassis and shields. This can inject

unnecessary AC voltage on the HDMI cable shield that can lead to DXLink signal integrity issues. To

check for indications of this type of power in the system, look for a two pronged plug or a cord that has

only two wires.

Note: Technically this type of grounding is only required when a DXLink Transmitter or Receiver is

connected to an ungrounded device, but this added grounding measure can be used at the

discretion of the installer.

Items Required

 Small adjustable wrench or socket driver

 6 foot ground wire with ring terminal ends (provided)

Note: Currently shipping DXLink Transmitters and Receivers provide a designated ground location

on the rear of the chassis for attaching a ground wire. For instructions on attaching a ground wire to

DXLink Modules or DXLink Wallplates with a designated ground location, see page 45.

Attaching a Ground Wire to a Common Earthed Ground

Connect the running end of the ground wire (fixed end attached to DXLink Module or Wallplate) to a

common earthed ground (ideally, referenced to the Enova DGX Switcher).

Important: If one DXLink Transmitter or Receiver is grounded, any remaining ungrounded units that

are connected to the same board on the Enova DGX Switcher must

also be grounded.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 153 154

No comments

AMX AVB-WP-TX-MULTI-DXLINK Instruction Manual Page 147