AMX MAX-CSD 10 Specifications download pdf (Page 95)

NetLinx Programming

MAX-CSE/MAX-CSD10 Operation/Reference Guide

RS-232/422/485 Send_Commands (Port 2)

The serial port is located at Port 2 in NetLinx D:P:S nomenclature. The serial port supports the

following commands and escape sequences. In these examples: <DEV> = device.

MAX-CSD Streaming Send_Commands (Cont.)

Command Description

START RTSP SERVER

Attempts to START the RTSP

SERVER and will retrieve

and update the session list

info.

If the RTSP SERVER started properly the 'GET SESSION LIST' table will

return with a 1. Otherwise it will return 0. This command is not accessible if

system mode is not set to RTSP

Syntax:

SEND_COMMAND <DEV>, 'START RTSP SERVER <num>'

Variables:

num = 1 to 10: One of the ten RTSP SERVER Entries.

Example:

SEND_COMMAND <DEV>, 'START RTSP SERVER 2'

STOP

Stops transmission of audio

and video.

Stops reception of audio and video.

Syntax:

SEND_COMMAND <DEV>,'STOP'

Example:

SEND_COMMAND DECODER, 'STOP'

RS-232/422/485 Send_Commands

Command Description

B9MOFF

Set the port's communication

parameters for stop and data

bits according to the software

settings on the RS-232 port

(default).

Disables 9-bit in 232/422/455 mode. By default, this returns the communication

settings on the serial/data port to the last programmed parameters. This

command works in conjunction with the 'B9MON' command.

Syntax:

SEND_COMMAND <DEV>,"'B9MOFF'"

Example:

SEND_COMMAND RS232_1,"'B9MOFF'"

Sets the RS-232 port settings to match the port's configuration settings.

B9MON

Override and set the current

communication settings and

parameters on the RS-232

port to 9 data bits with one

stop bit.

Enables 9-bit in 232/422/455 mode. This command works in conjunction with

the 'B9MOFF' command.

Syntax:

SEND_COMMAND <DEV>,"'B9MON'"

Example:

SEND_COMMAND RS232_1,"'B9MON'"

Resets the RS-232 port's communication parameters to nine data bits, one

stop bit, and locks-in the baud rate.

CHARD

Set the delay time between

all transmitted characters to

the value specified (in 100

Microsecond increments).

Syntax:

SEND_COMMAND <DEV>,"'CHARD-<time>'"

Variable:

time = 0 - 255. Measured in 100 microsecond increments.

Example:

SEND_COMMAND RS232_1,"'CHARD-10'"

Sets a 1-millisecond delay between all transmitted characters.

1 ... 94 95 96 ... 110

Comments to this Manuals

No comments

AMX MAX-CSD 10 Specifications Page 95

Comments to this Manuals

Related products and manuals for Servers AMX MAX-CSD 10