AMX MAX-CSD 10 Specifications download pdf (Page 19)

MAX-CSE and MAX-CSD10 Installation

MAX-CSE/MAX-CSD10 Operation/Reference Guide

Ethernet/RJ-45 Port: Connections and Wiring

The following table lists the pinouts, signals, and pairing for the Ethernet connector.

FIG. 6 diagrams the RJ-45 pinouts and signals for the Ethernet RJ-45 connector and cable.

•ETHERNET: RJ-45 connector routes streamed Audio/Video and Data out to an

external device capable of receiving the streamed media content

(including a MAX-CSD10, VG-Series touch panel, or computer).

The Power-over-Ethernet (PoE) feature of the Ethernet port can be

used to provide indirect DC power to this 802.3af-compliant device

over the unused wire pairs in the UTP or STP Ethernet cable

(RJ-45 pins 4, 5, 7, and 8).

• AUDIO IN: Stereo line-level input via two rear RCA connectors (R/L).

• MIC IN: Stereo line-level input via a rear 1/8” mini-stereo jack.

•IR: 2-pin 3.5 mm mini-Phoenix connector accepts a single IR Emitter

(CC-NIRC) and can connect one IR- or Serial-controllable device.

• I/O: 4-pin 3.5 mm mini-Phoenix connector allows for the connection of up

to two devices. The I/O port responds to either switch closures,

voltage level (high/low) changes, or can be used for logic-level

outputs. When used for outputs, the I/O port acts as a switch to GND.

Ethernet RJ-45 Pinouts and Signals

Pin Signals Connection

Pairing Color

1 TX + 1 --------- 1 1 --------- 2 Orange-White

2 TX - 2 --------- 2 Orange

3 RX + 3 --------- 3 3 --------- 6 Green-White

4 no connection 4 --------- 4 Blue

5 no connection 5 --------- 5 Blue-White

6 RX - 6 --------- 6 Green

7 no connection 7 --------- 7 Brown-White

8 no connection 8 --------- 8 Brown

FIG. 6

RJ-45 wiring diagram

1 ... 18 19 20 ... 110

No comments

AMX MAX-CSD 10 Specifications Page 19