AMX MAX-CSD 10 Specifications download pdf (Page 55)

Configuring Communication

MAX-CSE/MAX-CSD10 Operation/Reference Guide

Configuring Communication

This section refers to steps necessary to both communicate and upgrade components for the MAX-CSE

and MAX-CSD10. Both MAX units are configured to be used as standalone units running on a network

capable of supporting the up to a 6Mbps data rate.

Before beginning:

1. Setup and configure your MAX unit. Make sure your cables are working properly and are

securely connected. Refer to the previous section on page 9.

2. Verify you have installed the latest version of NetLinx Studio on your PC.

3. If an update is necessary, download the latest Studio software by first logging in to www.amx.com

and then navigate to Tech Center > Downloadable Files > Application Files >

NetLinx Studio 2.4. This program is used to setup a System number, obtain/assign the IP/URL for

the connected NetLinx Master, and transfer firmware Kit files to the Master.

4. Verify you have download the latest version of your target’s firmware (MAX-CSD10/Modero

panel) or software (third-party computer streaming application).

5. Verify the NetLinx Master is receiving power and is turned On.

Reading the Front Panel LCD

The LCD not only displays the currently used IP Address information, but can also provide the user with

current device status messages such as those given below in FIG. 31.

FIG. 31 LCD status messages

Currently used IP Address

Firmware upload in progress

Device is idle, no stream

in progress

Device is currently streaming

Device is currently rebooting

Device is being reset to its factory

default settings and then rebooting

1 ... 54 55 56 ... 110

No comments

AMX MAX-CSD 10 Specifications Page 55