AMX NXD-500i Specifications download pdf (Page 135)

Programming

123

NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom

Panel IR Commands

These commands are used to transmit and receive IR signals from the panel.

Each panel has up to 4 transmit ports specifically defined as IR output ports:

AMX 38K

AMX 455K

User 1

User 2

The ^IRM command allows the command itself to specify the port number. IRM is needed because

commands programmed on the panel itself can only be sent to a single port number.

The ^IRS command is needed to enable the received AMX 38K or 455k. In some cases, both of these ports

cannot be enabled at the same time.

Panel IR Commands

^IRM Pulses the given channel IR on for onTime in tenths of seconds.

Delays offTime tenths of seconds before the next IR pulse is allowed.

The port for the IR is specified in the command.

Syntax:

SEND_COMMAND <DEV>,"'^IRM-<port>,<channel>,<onTime>,<offTime>'"

Variables:

None.

Example:

SEND_COMMAND TP1,"'^IRM-<port>,<channel>,<onTime>,<offTime>'"

SEND_COMMAND TP2,"'^IRM-<port>,<channel>,<onTime>,<offTime>'"

Specifies the port number to be used.

^IRS Enable the received AMX 38K or 455K

The RX Ir port is specified in the command.

Syntax:

SEND_COMMAND <DEV>,"'^IRS-<port>'"

Variables:

None.

Example:

SEND_COMMAND <DEV>,"'^IRS-<port>'"

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 153 154

No comments

AMX NXD-500i Specifications Page 135