AMX MET-7 Specifications download pdf (Page 29)

Wiring and Connections

Metreau Keypads

AxLink Status LED

The AxLink Status LED (located next to the AxLink connector), lights to indicate AxLink power/data status as

follows:

If the LED is on and not flashing, disconnect the AxLink connector and recheck all AxLink connections.

Then, reconnect the AxLink connector to the panel and verify the LED is flashing once per second.

SWT Wiring

DAS-MET-6SRC and DAS-MET-7 Rear Panel Components

FIG. 21 shows the basic rear components of the SWT (DAS-MET-6SRC and DAS-MET-NUM) keypads:

Cable Type

SWT wiring involves connecting the Mi-Series Controller, Metreau keypads, and speakers.

The Mi-Series Controller and Metreau keypads are cabled using standard four-conductor speaker cable

originating at the Controller, passing through the keypad, and terminating at the speaker location.

AMX recommends using a bundled four-conductor 16-gauge stranded copper wire in a single continuous run.

Preparing Captive Wires

SWT wiring utilizes four-color "snap connectors" to secure the wires (no screws). You will need a wire

stripper to prepare and connect the captive wires.

If you are not using power from AxLink, disconnect the wiring from the controller

before wiring the Metreau keypad. Make sure the auxiliary power supply’s PWR (+) is

not connected to the controller’s AxLink connector.

AxLink LED Status

• 1 blink per second: Indicates power is active and AxLink communication is working.

• Full On: Indicates the following conditions:

• There is no AxLink control or activity, but power is On.

• The Axcess program is not loaded.

Before touching the device, discharge the static electricity from your body by touching

a grounded metal object.

FIG. 4 DAS-MET-6SRC and DAS-MET-NUM - Rear Components

SWT connector

(from Matrix Controller)

SWT connector

(To speakers)

not used

14-pin connector

(To DAS-MET-NUM)

DAS-MET-6SRC DAS-MET-NUM

14-pin connector

(From DAS-MET-NUM)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 83 84

No comments

AMX MET-7 Specifications Page 29