AMX PTM-D15 Service Manual download pdf (Page 61)

Remote Control Unit (continued)

Using the Remote Control Unit

SENSOR button When you press this button (use a small-tipped object such as a ballpoint pen),

the mark will appear at the display. And the room temperature is detected by

the sensor which is built into the indoor unit and the air conditioner is controlled

accordingly.

If the remote control is located near a heat source, such as a space heater or in

direct sunlight, press the SENSOR button to switch to the sensor on the indoor

unit.

Temperature Display Selector

button

This switches the temperature display between °C and °F.

Time Display Selector button This switches the time display between 24-hour time and 12-hour time.

ACL button (ALL CLEAR) Puts the remote control unit into pre-operation status. Always press this button

after replacing the batteries.

ADDRESS switch • The address switch changes to prevent mixing of signals from remote control

units when two air conditioners are installed next to each other. Normally, the

address switch is set to A. For more information, please contact the dealer

where you made the purchase.

• Normally, the tabs on the remote control unit should not be bent.

The remote control unit sends the temperature signal to the air conditioner regularly at five minute

intervals. If the signal from the remote control unit stops for more than 15 minutes due to the loss of the

remote control unit or other trouble, the air conditioner will switch to the temperature sensor which is built

into the indoor unit and control the room temperature. In these cases, the temperature around the remote

control unit may differ from the temperature detected at the air conditioner’s position.

How to Install Batteries

• The batteries last about six months, depending on how much you use

the remote control unit. Replace the batteries when the remote control

unit’s display fails to light, or when the remote control cannot be used to

change the air conditioner’s settings.

• Use two fresh leak-proof type-AAA alkaline batteries.

• In replacing batteries, follow the instructions as mentioned in the sub-

section “How to Install Batteries”.

• If you do not use the remote control unit more than 1 month, take out the

batteries.

NOTE

1. Slide the cover in the direction

indicated by the arrow and remove it.

2. Install two AAA alkaline batteries.

Make sure the batteries point in the

direction marked in the battery

compartment.

3. Use a thin object such as the tip of a

pen to press the ACL button.

ACL button

NOTE

OI-802-10-EG

01_KHS0971_EN.fm Page 10 Tuesday, September 27, 2005 2:53 PM

1 ... 60 61 62 ... 77

Comments to this Manuals

No comments

AMX PTM-D15 Service Manual Page 61

Comments to this Manuals

Related products and manuals for TVs & monitors AMX PTM-D15