AMX AXU-CA10 Installation Guide download pdf (Page 2)

WARNINGS

Due to safety reasons, alarm system should be installed by qualified personnel only.

Telephone terminals of the panel should be connected to PSTN lines only.

Connecting to ISDN lines may lead to damage of the equipment.

Because alarm system may contain hazardous items, its components should be kept

out of reach of unqualified personnel.

In order to avoid the risk of electric shock, read carefully this manual before

proceeding to installation. Any connections should be made in deenergized state

only (i.e. with power supply disconnected).

In the event of service operations consisting in fuse replacement, they must only be

carried out after disconnecting the supply voltage. For the replacement, use only the

fuses which have identical parameters as the original ones.

It is recommended that the manufacturer’s required housings and power supply units

be used .

Making any construction changes or unauthorized repairs is prohibited. This applies,

in particular, to modification of assemblies and components.

CAUTION !

It is impermissible to connect a fully discharged battery (voltage on terminals without

a load less than 11V) to the alarm panel. To avoid hardware damage, fully

discharged or never used battery should be precharged using proper charger.

The batteries used in the alarm systems contain lead. The old batteries must not be

thrown away, but disposed of as required by the existing regulations (European

Directives 91/157/EEC and 83/86/EEC).

CERTIFICATE of CONFORMITY

Equipment type:

Control panel CA-10

Manufactured by:

SATEL sp. z o.o.

POLAND

Complies with

Directives of the Council of the European Union:

Low Voltage Directives 73/23/EEC revised by 93/68/EEC

EMC Directive 89/336/EEC revised by 91/263/EEC, 92/31/EEC, 93/68/EEC

R&TTE Directive 1999/5/EC (network connection, TBR21)

GDAŃSK, date:

2003-11-03

Head of Test Laboratory: Stanisław Galla

NOTE!

The control panels with internal pulse power supply require a different approach (as compared with the

previously manufactured CA-10v3.x panels) during the power-up procedure. Refer to the section on

connecting power supply and starting the control panel.

History of the manual updates

–

see the

end of this manual.

1 2 3 ... 84

Comments to this Manuals

No comments

AMX AXU-CA10 Installation Guide Page 2

Comments to this Manuals

Related products and manuals for TVs & monitors AMX AXU-CA10