AMX D-1000 Specifications download pdf (Page 19)

Installation

MXD/T-1000 10.1" Modero X Series® Touch Panels

Installation

MXT-1000 Installation

Any USB peripherals (mouse, keyboard, etc.) may be connected to one of the two USB ports on the rear of the device

(FIG. 9). Updates to the device’s firmware are also made via the USB ports. The 5-pin Micro-USB port is used

exclusively for camera video and microphone output only.

Power via Power Over Ethernet

Power for the MXT-1000 is supplied via Power Over Ethernet (PoE), utilizing an AMX-certified, capacitive touch-

compliant PoE injector such as the PS-POE-AT High Power PoE Injector (FG423-81) or other approved AMX PoE

power source. The incoming Ethernet cable should be connected to the RJ45 port on the cable attached to the device

(FIG. 10).

Ethernet Cable Installation and Modification

In installations where you wish to conceal the Ethernet cable, a hole at least 1.00” (2.54 cm) in diameter is required in the

surface to allow passage of the female RJ45 connector (FIG. 11). If using a smaller hole is unavoidable, you will need to

disconnect the Ethernet cable (ECA5968-05) from the device.

FIG. 9 Connectors on the rear of the MXT-1000

FIG. 10 Back of the MXT-1000, showing RJ45 port and cable for PoE

Micro-USB

USB Ports

Entry for RJ45/

PoE Cable

Port

Speaker

Cable length

edited for clarity

RJ45 Port

The minimum diameter hole through which the Ethernet cable may pass is 0.50"

(1.27 cm).

1 ... 18 19 20 ... 42

No comments

AMX D-1000 Specifications Page 19