AMX Advanced Classroom Transmitter TXC-ACT Specifications download pdf (Page 5)

Assembly & Connection

In the Box:

Main controller X1, PMU X1, GPS X1, GPS Bracket X1, LED X1, Servo Cable X8, Micro-USB Cable X1, CAN Cable X1,

3M Adhesive Tape.

Step1 Port Description

LED:Connect to LED module

EXP:Connect to PMU module

M1: To #1 ESC(*)

M2: To #2 ESC

M3: To #3 ESC

M4: To #4 ESC

M5: To #5 ESC

M6: To #6 ESC

F1: To gimbal roll servo or To #7 ESC

F2: To gimbal pitch servo or To #8 ESC

NAZA output is 400Hz refresh frequency

A: For roll control (left/right)

E: For pitch control (front/back)

T: For throttle control

R: For rudder control

U: For Control Model Switch

X1: For gimbal pitch control / For gain tuning

X2: For D-Bus(S-Bus compatible) / For gain tuning / For IOC switch

X3: For voltage monitor(Connect to PMU V-SEN port)

GPS: Connect to GPS/Compass module

Extended CAN port

2S~6S: Powered by 2S~6S LiPo(7.2V~26.0V)

EXP: Connect to Main

Controller EXP port

Connect to Main Controller LED port

Micro-USB: PC connection

for parameter configuration

and firmware upgrade

Connect to GPS port of PMU

Pointing to the aircraft nose direction

Main Controller

PMU

(Power Management Unit)

LED

GPS/Compass

Pointing to the aircraft nose direction

*ESC: Electronic Speed Controller

V-SEN: Connect to Main Controller X3Port

Important: the continuous output of the

PMU is 3A@5V, and the maximum

instant current is 7.5A. If PMU cannot afford

the working current for your servos, please

use an independent power supply; otherwise,

it may cause the PMU safeguard and lead to

the main controller reboot。

1 2 3 4 5 6 7 8 9 10 ... 26 27

Comments to this Manuals

No comments

AMX Advanced Classroom Transmitter TXC-ACT Specifications Page 5

Comments to this Manuals

Related products and manuals for Unknown AMX Advanced Classroom Transmitter TXC-ACT