AMX MVP-5150 Specifications download pdf (Page 41)

Configuring Communication

MVP-5100/5150 5.2" Modero Viewpoint Touch Panels

4. Select a desired Access Point by touching the corresponding row. The up arrow and down arrow

will be grayed out if ten or fewer access points are detected. If more are detected, then they will be

enabled as appropriate so that the user can scroll through the list.

5. With the desired AP selected and highlighted, click the Connect button to be directed to the

selected security mode’s popup window with the SSID field filled in. From there, either Cancel the

operation or fill in any necessary information fields and then click Save.

Step 2: Configure the Card’s Wireless Security Settings

The second step in setting up the wireless card is to configure the Wireless Settings section of the

Wireless Settings page. This section configures both the communication and security parameters from

the internal wireless card to the AP. The procedures outlined within the following sections for an

802.11g card facilitate a common security configuration to a target AP.

Refer to the Appendix B: Wireless Technology section on page 165 for more information on other

security methods.

After setting up the wireless card parameters, configure the communication parameters for the target

Master; see Panel Downloads and Firmware Updates section on page 34.

Configuring the device’s wireless card for unsecured access to an AP

In the Protected Setup page:

1. Press the Wireless Settings button (located on the lower-left) to open the Wireless Settings page

(FIG. 16).

2. Enter the SSID information by:

Automatically filling it by pressing the Site Survey button. From the Site Survey page,

choosing an Open AP from within the Site Survey page and then pressing the Connect button

at the bottom of the page (FIG. 17).

If the panel detects more than 10 APs, the Up/Down arrows at the far right side of the

page become active (blue) and allow the user to scroll through the list of entries.

FIG. 16 Wireless Settings page (showing a sample unsecured configuration)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 189 190

No comments

AMX MVP-5150 Specifications Page 41