AMX EXB-COM2 Specifications download pdf (Page 68)

Terminal (Telnet) Commands

ICSLan Device Control Boxes

Linux Telnet Client

The Linux Telnet client has three anomalies that are known at this time:

A null (\00) character is sent after a carriage return.

If an ALT 255 is entered, two 255 characters are sent (per the Telnet RAFT).

If the code to go back to command mode is entered (ALT 29 which is ^]), the character is not sent,

but Telnet command mode is entered.

Enabling / Disabling Telnet on EXB Modules

By default, Telnet is enabled on all EXB Modules. The default Telnet port is 23.

The Telnet port can be changed via the SET TELNET PORT command (see page 59). Setting the Telnet port

to zero will disable Telnet access.

The SET TELNET PORT command requires a reboot to enable new settings.

The only way to re-enable Telnet once it has been disabled is to reset the unit to the

factory default firmware image. See the Resetting the Unit to the Factory Default

Firmware Image section on page 14 for details.

1 2 ... 63 64 65 66 67 68 69 70

No comments

AMX EXB-COM2 Specifications Page 68