AMX EXB-COM2 Specifications download pdf (Page 15)

Installation

ICSLan Device Control Boxes

SAFETY INSTRUCTIONS

For UL compliance, the EXB family of ICSLan Device Control Boxes should be powered directly

via any listed external IEC/UL 60950-1 2nd edition certified LPS PoE switch or injector, such as

the AMX NXA-ENET8POE or PS-POE-AF.

The EXB family of ICSLan Device Control Boxes are intended for Network Environment 0 per

IEC TR62101, and are to be connected only to PoE networks without routing to the outside plant.

Preparing/Connecting Captive Wires

1. Strip 0.25 inch of wire insulation off all wires.

2. Insert each wire into the appropriate opening on the connector according to the wiring diagrams and

connector types described in this section.

Do not tighten the screws excessively; doing so may strip the threads and damage the connector.

LAN/PoE Port

The LAN/PoE (RJ45) port on all EXB Modules provides 10/100 BaseT network connectivity. Use standard

Cat5/6/6E ethernet cable to connect the EXB Module to the LAN. The following table lists the pinouts,

signals, and pairing for the Network port.

The Ethernet Port LEDs show communication activity, connection status, speeds, and mode information:

SPD (speed) - Yellow LED lights On when the connection speed is 100 Mbps and turns Off when

the speed is 10 Mbps.

L/A (link/activity) - Green LED lights On when the Ethernet cables are connected and terminated

correctly, and blinks when receiving Ethernet data packets.

LAN/PoE Port Pinouts and Signals

Pin Signals Connections Pairing Color

1 TX + 1 --------- 1 1 --------- 2 White-Orange

2 TX - 2 --------- 2 Orange

3 RX + 3 --------- 3 3 --------- 6 White-Green

4 DC + 4 --------- 4 Blue

5 DC + 5 --------- 5 White-Blue

6 RX - 6 --------- 6 Green

7 DC - 7 --------- 7 White-Brown

8 DC - 8 --------- 8 Brown

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 69 70

No comments

AMX EXB-COM2 Specifications Page 15