ViewStat Installation and Wiring
11
ViewStat Communicating Thermostat
9. Connect the Cat-5 RJ-45 connector on the MiniVerter to the Control System (Master or ICSNet Hub).
Wiring the VST-TSTAT to a VST-DIST Distribution Panel
The optional VST-DIST Distribution Panel (not included) connects to up to eight VST-TSTAT thermostats,
providing a convenient and effective method of wiring multiple thermostats to the control system's RS422
serial interface port.
The VST-DIST provides one RS422 interface to the control system and eight RS422 interfaces for the
thermostats.
Since the VST-DIST provides an RS422 interface to the control system, a MiniVerter (VST-MVRT)
is not required for communication.
The VST-DIST is intended for use with the VST-TSTAT, and is not intended for use with the VST,
which includes a MiniVerter.
FIG. 6 Inserting the MiniVerter into the mounting bracket (top view).
2
3
1
Insert the MiniVerter
(connector-side down)
into the guide slots
inside the mounting bracket.
Slide the MiniVerter into
locking position in
the bracket.
Snap into place
ViewStat base (top view)
MiniVerter
MiniVerter card
mounting bracket
Repeated installation and removal of the MiniVerter bracket may result in damage to
the bracket.
The VST-DIST includes an Instruction Manual from the manufacturer with detailed
installation instructions, and a decal on the inside of the front cover (reproduced in
FIG. 7) gives wiring information for the panel.
Comments to this Manuals