Amx ViewStat User Manual download pdf (Page 16)

ViewStat Installation and Wiring

ViewStat Communicating Thermostat

Attaching the MiniVerter to the ViewStat

Before attaching the MiniVerter to the rear of the ViewStat, connect the wiring, as described below:

1. Detach the faceplate from the base of the ViewStat.

2. Pull the stripped/tinned wires through the cutout in the center of the base (FIG. 5).

Before mounting the ViewStat, you must attach the MiniVerter to the rear panel of the ViewStat, as described

below:

1. Detach the faceplate from the base of the ViewStat.

2. Pull the stripped/tinned wires through the cutout in the center of the base (FIG. 5)

3. Connect the communications wiring:

a. Blue to B-

b. Orange to B+

c. Red/White to A-

d. Black/White to A+

4. Connect the power wiring:

a. Black to C

b. Red to R

5. Install a jumper from RH to RC.

6. Insert the MiniVerter (connector-side first) into the guide-slots located on the bottom of the MiniVerter

mounting bracket (FIG. 6).

7. Slide the MiniVerter back into its locking position in the mounting bracket.

8. With the connector-side of the MiniVerter seated in the guide-slots, gently press the opposite side of the

MiniVerter in and down, to snap it into its locked position on the mounting bracket.

FIG. 5 ViewStat base with Communication, Power and Equipment terminals

ommon

(bl

from 24 VAC

HVAC System

Power (red)

from 24 VAC

HVAC System

jumper

from RC

to RH

from Miniverter

Communication

Terminal

cutout

Equipment

terminal

Power

Ter min a l

1 ... 15 16 17 ... 68

No comments

Amx ViewStat User Manual Page 16