Amx Modero NXD-CV5 User Manual download pdf (Page 82)

Firmware Pages and Descriptions

NXD-CV5 5" Modero Wall/Flush Mount Touch Panel

Calibration Page

This page (FIG. 66) allows you to calibrate the touch panel using the pre-selected touch driver.

 Press and hold the grey Front Setup Access button (below the Modero LCD) for 6 seconds to access

the Calibration page.

 Press the crosshairs to calibrate the panel and return to the last active firmware page.

G4 Web Control Page

The G4 Web Control page (FIG. 67) centers around enabling and disabling both the display and control of

your panel (via the web). An external PC running a VNC client (installed during the initial communication to

the G4 panel) makes this possible.

Each panel supports the open standard Virtual Network Computing (VNC) interface. These panels contain a

VNC server that allows them to accept a connection from any other device running a VNC client.

Once a connection is established to that target device, the client can control the touch panel remotely.

The elements of the G4 Web Control page are described in the table below:

FIG. 66 Calibration page (actually 3 separate screens)

The request to touch the crosshairs

is the first on-screen message

Calibration successful is the second

on-screen message that appears

On-screen crosshairs used for

calibration of the touch device

after the calibration process is

completed

If the calibration was improperly set and you cannot return to the Calibration

page (through the panel’s firmware); you can access this firmware page via

G4 WebControl where you can navigate to the Protected Setup page and press the

Calibrate button through your VNC window.

This action causes the panel to go to the Calibration page seen above, where you

can physically recalibrate the actual touch panel again using the above procedures.

FIG. 67 G4 Web Control page

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 151 152

No comments

Amx Modero NXD-CV5 User Manual Page 82