AMX R-2 User Manual download pdf (Page 22)

Mio Remote Charging Base

Mio Modero R-2

9. Press the battery between the rubber pads, with sticker showing, in the housing area of the Mio

remote. Confirm battery is flush with bottom of battery enclosure on bottom housing.

10. Replace the battery door and slide to lock it in place.

11. Begin charging the battery.

Charging The Mio Remote with Charging Base

The Mio remotes receive power for charging from a charging base.

1. Connect the terminal end of the power supply to the bottom external power port on the Mio remote

charging base. See FIG. 6 for location.

2. Route the cable through the provided channel so that it comes out the side of the base.

3. Connect the power cord to an external power source.

4. Place the bottom of the Mio remote into the charging base so the contacts on the device are on top of

the charging contacts inside the charging base. The Power LED on the Mio remote blinks red to

indicate it is charging and illuminates solid red when it is done. Full charge cycle for a depleted

battery is approximately 3 hours.

Avoid placing units equipped with AAA batteries in the charging base.

Changing Battery Modes

Configuration Mode

The configuration mode allows you to set the battery type. To enter configuration Mode:

1. Press and hold the STOP button and the INPUT button simultaneously. The two buttons must be

pressed within 0.1 seconds of each other and held down for 2 seconds. The device indicates you are

now in configuration mode. See below for available modes.

Battery Type

Pressing button "6" on the remote toggles the battery type between Normal and Recharge. The

display indicates the selected type. The type of battery in the Mio R-1 dictates the battery type you

need to set.

3. Press the EXIT key when you are finished.

Your settings will not be lost in the event your batteries die or are removed.

1 ... 21 22 23 24

No comments

AMX R-2 User Manual Page 22