AMX NXP-CPI16 User Manual download pdf (Page 13)

NXP-CPI16 NetLinx Custom Panel Interface

Each of the two 20-pin connectors is assigned a group of 8 input and output channels. The table below

shows the relation of input and output channels in the STATUS modes.

The NXP-CPI16 may be configured to default to STATUS-ON mode using the following method. The

commands can force a change to the mode no matter what default mode is configured for the device.

STATUS-ON Mode:

Remove R7 (1K ohm) resistor OR short across R8 for STATUS-ON mode. Firmware remains the same

for standard and STATUS-ON mode NXP-CPI16 units.

Input/Output STATUS Mode

Mode Connector STATUS-OFF (default) STATUS-ON

Inputs J3 Chan 1-8 Chan 1-8

J4 Chan 9-16 Chan 17-24

Outputs J3 Chan 1-8 Chan 9-16

J4 Chan 9-16 Chan 25-32

1 ... 12 13 14 15 16 17 18

No comments

AMX NXP-CPI16 User Manual Page 13