AMX MXD-701 Instruction Manual download pdf (Page 36)

Installing Tabletop (MXT) Panels

Modero X® Series G5 Touch Panels Instruction Manual

MXT-1001 / MXT-701

Detailed specifications drawings for the MXT-1001 and MXT-701 are available to download from www.amx.com.

Connector Locations - MXT-1001/MXT-701

Two Type A USB ports are located on the rear right corner of the panel (FIG. 17). USB peripherals (i.e. mouse,

keyboard) may be connected to either of the two USB ports on the rear of the device. Updates to the device’s firmware

can also made via the USB ports (see Upgrading Firmware via USB Flash Drive on page 57 for details). Note that

FIG. 17 shows the MXT-1001, but the USB ports are in a similar location on the MXT-701.

Power via 12 VDC

The MXT-2001-PAN and MXT-1901-PAN use a 12 VDC-compliant power supply to provide power to the panel via the

2-pin 3.5 mm captive wire PWR connector. The incoming PWR and GND wires from the power supply must be

connected to the corresponding locations within the PWR connector.

Wiring a 12VDC Power Connection

To use the 2-pin 3.5 mm captive wire connector with a 12 VDC-compliant power supply, the incoming PWR and GND

wires from the external source must be connected to their corresponding locations on the connector (FIG. 18). The

connector uses locking screws to insure a connection to the device, so make sure to insert and tighten the screws before

applying power.

1. Insert the PWR and GND wires on the terminal end of the 2-pin 3.5 mm captive wire cable.

Match the wiring locations of the +/- on both the power supply and the terminal connector.

2. Tighten the clamp to secure the two wires.

FIG. 17 MXT-1001 - rear view

USB Ports

Entry for RJ45/PoE Cable

Refer to the Power via PoE section on page 31 for details on PoE and Ethernet Cable

Installation and Modification.

Connecting power to the panel should be done using the included 2-pin 3.5mm

captive wire connector included with the device. This connector is retained within its

port with locking screws instead of the pins on each side of standard captive wire

connectors, and using force to insert a standard captive wire connector may damage

the device.

FIG. 18 NetLinx power connector wiring diagram

PWR +

GND -

To the Touch Panel

Power Supply

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 73 74

No comments

AMX MXD-701 Instruction Manual Page 36