Amx NXA-UPS1500 User Manual download pdf

Installation Guide

NXA-UPS1500 (120v/240v)

Uninterruptible Power Supply

NXA-UPS1500 (120v/240v) UPS

The NXA-UPS1500 is a Uninterruptible Power Supply (UPS) featuring Double AVR Boost

and Double Buck, Pure Sine Wave Output, LCD Display and Hot-Swappable Battery. The

NXA-UPS1500 supports RS232 control. The NXA-UPS1500 is available in two voltages:

• 120V (FG678-15)

• 240V (FG678-20)

The NXA-UPS1500 features tower/rack-convertible design making it ideal for use with AMX’s

line of MAX devices (FIG. 1).

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS: This manual contains important safety instructions. Please

follow all instructions carefully during installation. Read this manual thoroughly before

attempting to unpack, install or operate.

CAUTION - To prevent the risk of fire or electric shock, install in a temperature and humidity

controlled indoor area, free of conductive contaminants.

CAUTION - Risk of electric shock, do not remove the cover. No user serviceable parts. Refer

servicing to qualified service personnel.

CAUTION - Risk of electric shock, hazardous live parts inside this UPS can be energized

from the battery supply even when the input AC power is disconnected.

WARNING - This is a Class A-UPS Product. In a domestic environment, this product may

cause radio interference, in which case, the user may be required to take additional

measures.

NOTICE - The UPS is designed to be for use with computer loads only.

NOTICE- To prevent injury, do not carry with the handle of front cover when moving the UPS.

Front Panel LCD and LEDs

FIG. 2 describes the elements of the front panel LCD:

DIP Switch Setting

The nominal voltage of the UPS can be reset by the DIP Switch on the rear panel of the UPS.

The following charts describe the voltage settings.

Indicators & Alarms

Setup Instructions

Connecting the Batteries

The UPS1500 ships with the four batteries installed inside the unit. Before use, you will need

to connect the main power connector inside the unit:

1. Remove the Release tabs on the front panel (see FIG. 1) to expose the screws that

secure the Battery Compartment Cover.

2. Remove the screws beneath the Release tabs (FIG. 4).

3. Remove the Battery Compartment Cover to access the Battery Compartment.

4. Remove the screw holding the metal securing piece in place.

5. Slide the metal securing piece into the groove on the 4-pin connector (red) from the

battery cable harness.

6. Connect the 4-pin connector to the matching connector inside the unit.

7. Reattach the metal securing piece above the connector with the screw (FIG. 5).

FIG. 1 NXA-UPS1500 Uninterruptible Power Supply

NXA-UPS1500 Product Specifications

Input:

• Voltage Window (DIP Switch selectable):

120V version (FG678-15): 110/115/120 Vac +35% ˜ -32%

240V version (FG678-20): 220/230/240 Vac +35% ˜ -32%

• Frequency: 45 ˜ 65Hz (50/60Hz auto-sensing)

Output: • Voltage Window (AC Mode):

120V version (FG678-15): 110/115/120 Vac +8% ˜ -12%

240V version (FG678-20): 220/230/240 Vac +8% ˜ -12%

• Voltage Window (INV Mode):

120V version (FG678-15): 110/115/120 Vac +/-5%

240V version (FG678-20): 220/230/240 Vac +/-5%

• Capacity (VA/W):1500/900

• Wave Form: Pure sine wave

• Frequency: 50Hz/60Hz +/-0.1Hz

• Transfer Time:2 ms typical

• Autonomy: > 8 min.

• DC Start: Yes

Battery: • Type: 12V, sealed lead acid maintenance-free

• Capacity: 9AH

• Quantity: 4 12V batteries required

• Voltage:

120V version (FG678-15): 24 Vdc

240V version (FG678-20): 48 Vdc

• Recharge Time: 2 ˜ 4 hours to 90%

• Storage: Store at -15 to +30 °C (+5 to +86 °F), charge the UPS

battery every 6 months / Store at +30 to +45 °C (+86 to +113 °F),

charge the UPS battery every 3 months.

LED indicators: • Utility mode

• Backup mode

• Battery conditions

Display LCD: • Load level (%)

• Battery level (%)

• Bypass

• AVR-Boost/AVR Buck

• Battery Low/Replace/Fault

• UPS Fault

• Site Wiring Fault

• Overload

Overload Protection: • AC Mode: >110% Buzzer continuously alarms, and shuts down in

10 minutes.

• Inverter Mode: >120% Buzzer continuously alarms, and shuts

down in 10 seconds.

Short Circuit Protection: • AC Mode: Breaker and electronic circuit

• Inverter Mode: Shut down automatically in 8 cycles

Self-Diagnostics: Upon Power-on

Alarms: • Line Failure

• Battery Low

• Overload and Fault

Operation Environment: • Temperature: 32° - 104°F (0-40° C)

• Operation Humidity: 95% RH Maximum, non-condensing

Dimensions (HWD): • 3.46” x 17.32” x 18.97” (8.80cm x 44.0cm x 48.2 cm)

• 2U rack height

Control Communication: RS-232

Weight (with batteries): 70.3 lbs (31.89 kg)

Certifications: • EN50091-1-1:1996 (Safety)

• FCC Part 15, Subpart B - Class A

• UL: YEDU.E166979

(front)

(rear)

Front Panel LCD

Battery Compartment

RS232 Communication Port

DIP Switch

USB Communication Port

RJ-45 Ports (Network Surge Protection)

Power Outlets

Output Breaker

Input Breaker

External Battery Terminal

Input Power Socket (Inlet)

Release tabs

NXA-UPS1500 Product Specifications (Cont.)

Included Accessories: • AC Input Power Cord

• Tower and rack-mounting accessories

Other AMX Equipment: NXA-UPS1500 EPM Extended Power Module (FG 678-16)

NXA-UPS1500ECJ, European Power Cable (FG 678-17)

NXA-UPS1500UKCJ, United Kingdom Power Cable (FG678-18)

NXA-UPS1500ACJ, Australian Power Cable (FG678-19)

FIG. 2 Front Panel LCD and LEDs

FIG. 3 DIP Switch Settings (sets nominal voltage)

Indicator Color Description Alarm

Utility Mode Green • Steady: Output Load is supplied by Utility.

• Blinking: Polarity error or Ground Fault.

None

Backup Mode Amber

• Steady (with alarm): Output Load is

supplied by Battery.

• Blinking every 5 seconds (no alarm):

Stand by for Utility recovery to re-start up.

Every 2 seconds before

battery Low and every 1

second before battery

Cutoff.

Fault Red When Overload, short circuit, or Output

Voltage Abnormal occurs.

Buzzer beeps

continuously

Battery

Replacement

N.A.

(LCD)

• Blinking: Battery is weak and needs to be

recharged.

• Steady: Battery is dead.

None

1. Utility (Green LED)

2. Fault (Red LED)

3. On Switch

4. Off Switch

5. Battery Replacement

6. Battery Backup (Amber LED)

7. Battery Low

8. Bypass

9. Utility Low, UPS Boost

10. Utility High, UPS Buck

11. UPS Output Indicator

12. Polarity Error or Ground Fault

13. Overload

14. Load/Battery Level (%)

15. Load/Battery Level

1234

891011

12 13

Indication Control Button

FUNCTION 2 1

VOLTAGE=110V

VOLTAGE=115V

VOLTAGE=120V

ON OFF

OFF OFF

OFF ON

FUNCTION 2 1

VOLTAGE=220V

VOLTAGE=230V

VOLTAGE=240V

ON OFF

OFF OFF

OFF ON

120V (FG678-15) 240V (FG678-20)

1 2

Summary of Contents

Page 1 - NXA-UPS1500 (120v/240v)

Installation GuideNXA-UPS1500 (120v/240v) Uninterruptible Power SupplyNXA-UPS1500 (120v/240v) UPSThe NXA-UPS1500 is a Uninterruptible Power Supply (U

Page 2 - Operation

Comments to this Manuals

No comments

Amx NXA-UPS1500 User Manual

Browse online or download User Manual for Tools Amx NXA-UPS1500. AMX NXA-UPS1500 User Manual

Summary of Contents

Comments to this Manuals