AMX PLB-CF10 Instruction Manual download pdf (Page 9)

PLB-CF2 Two-Slot Mini Cardframe Operation Instructions 5

Operation Instructions

Power-Up Procedure

1. Plug the power cord into a properly grounded 110-120VAC outlet.

2. Plug the 12 VDC power supply connector into the 12 VDC receptacle on the

rear panel of the PLB-CF2.

3. The Power LED should be illuminated on the front panel. If there is a problem,

contact your PHAST dealer or PHAST Technical Support.

PhastLink Ports

There are two PhastLink ports on the lower part of the rear panel. These are used to

connect PhastLink devices to the cardframe. If more ports are required, an

additional cardframe or hub box will be necessary. It does not matter which

PhastLink port you use; they are all functionally identical. See the section on

PhastLink Wiring for general information about connecting PhastLink devices.

MCU-to-PC Connection

If a PHAST MCU card is installed, a 10Base-T Ethernet port on the MCU card is

used to connect the to an ethernet board in the PC. See the PHAST PLC-MCU

documentation for more information on connecting and using the MCU card.

Device Address

A DIP switch on the rear panel allows you to set the cardframe address to match its

address in the Landmark software. The following illustration shows the address

settings (factory default is 0):

Figure 4

DIP Switch settings

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

AMX PLB-CF10 Instruction Manual Page 9